Yes...I've tried adjusting the level but no results with that either. I'll keep at it and figure it out. Thanks for pointing me in the right direction.

@jaredbusch

OK...back at this site this afternoon and I've got a pair of wires run now from the speaker connection (red and black) on the SNOM PA1 to the 8Ω input there on the amp. In the Preferences->PA1 Controls section in the SNOM settings, amplifier gain is set to 0. I still hear nothing on the two loudspeakers connected to the amp. Not sure what I would be missing.

Sounds good...I'll give it whirl and see what happens. Thanks!

@jaredbusch

I ran across this post in searching for some information in hooking up an SNOM PA1 to an amp that I inherited in a building setup here and I'm still confused in my particular situation after looking at the picture you provided. There was a crown amplifier that was already in place and two speakers (70v speakers) in the shop area hooked to that and I want to hook the SNOM PA1 to that amp to page over the loudspeakers, but I'm unsure if I need an impedance adapter or something between the SNOM and the amp. Here's picture of the back of the amp:

(

If I hook a traditional speaker up via the line out on the SNOM I'm able to hear everything as I would expect when paging over that speaker, but do you have any advice as to what the hookup to the amp would look like? Would I need an adapter that splits line out to either input 2 or 3? Or something else entirely? Thanks.